Go through the wires. Always check each one, including those linked to heat factor, thermostats, etc. Get hold of the wires and ensure they are all okay. Work with a flashlight or difficulty gentle if required to see them. Often there’s one that’s burnt at the terminal, therefore is disconnected. This is often quickly repaired by cutting off the burned conclusion, and putting a brand new fastener on the end of it.
If the wires are okay, then check the thermostats, the little circular devices on heat element. This may quickly be performed by disconnecting the wires from their website, and utilizing a continuity tester to see if recent may movement through them. When there is an open circuit, replace it with a brand new one. If they’re fine, always check heat element. Many dryers have temperature elements with two terminals. Remove the cables and check heat aspect with a continuity tester.
You can purchase a continuity specialist at the store for around $15. You can even make a easy one by taking a flashlight battery, lamp, and some wire. Solder a bit of cord to the underside of the battery, and another item to the the top of battery. Solder among the cables aside of the bulb. It does not subject which wire. Solder yet another wire to the tip of the bulb. Clean the ends of both cables, which are left. Your tester is created! Check it by pressing the two wires together. The light must light. So now just feel the 2 wires to both temperature factor terminals, or the thermostat terminals. If the bulb fires up then a part is okay.
If the warmth factor is poor, obtain a new one and change it. To take the old factor out you will have to unfasten the top of the dryer and raise it up. This is done by moving a putty knife among the top and the case in front, about 3″ from the medial side of the dryer on equally sides. That produces the two fasteners that maintain the front of the very best down.
At once drive an appartment screwdriver between the most effective and the case in the middle of the front. If the fasteners were released you will have the ability to simply lift the leading, and it may be forced long ago and sleep it on a wall behind the kenmore dryer repair. If the utmost effective doesn’t raise simply look for the release films and force them back with the putty knife. On the the surface of the temperature factor is one screw. That is all that keeps heat aspect in. The bottom of it gels a dance to carry it.
Draw a picture of where the wires are attached to heat factor and the thermostat or thermostats. Then remove the cables from the warmth aspect and thermostats privately of the heater housing. Take out the main one secure at the the surface of the housing. Force the housing towards the trunk till it comes from the position it sets in.
Then lift it out if the underside slots and it may be quickly taken off underneath back of the dryer. Eliminate the one mess near the bottom of it and take the heat element out of the housing. Put the newest one in and fasten it with the screw. Reassemble the element and the dryer by refastening everything, like the wires, right back, etc. Put the dryer cord in and change it on to ensure it heats.